Liquid AR is a thicker version of the original Fluid Film formula. It is suitable for areas that are highly susceptible to abrasions or washing off such as wheel wells. If you think of the standard Fluid Film as having the viscosity of latex paint and Liquid-A having the viscosity of vegetable oil, then you can visualize Liquid-AR like gel or a light grease. Due to this thicker viscosity, Liquid-AR must be applied with a stiff brush or trowel, and will not work with a sprayer.
Fluid Film Liquid AR is like standard Fluid Film in that there are no solvents in the product. When there are no solvents, there are almost no VOCs to evaporate. With very low VOCs, everything that you apply stays on the surface to protect it from rust. Not only is this method more user friendly, but it allows the product to go further per ounce than solvent-based products.
Fluid Film Liquid AR rust preventer can be applied to just about any surface. Since it is a non-drying product, it will leave a thick wet film.
The typical coverage rate for Fluid Film Liquid AR is 100sq ft per gallon when applied at 16 mils thickness.
Because this pail contains no aerosols or solvents, this product can be shipped by air if needed.
1 gallon pail.
Made in the USA.